-
Hi,
I downloaded miRge based on the installation guide. The directories are below:
bowtie: /opt/bowtie1.1.2/bowtie
samtools: /usr/local/bin (compiled from source, version 1.5)
ViennaRNA: /usr…
-
What were you doing?
Sent a gcode file to print. It goes thorugh the GPX plugin though. Happens with any file I submit.
What did you expect to happen?
terminal showing each command followed by OK.
…
-
I'm using a Qidi Tech I (Replicator clone running Sailfish v78), and I can't connect to it from Cura 3.1. I've stopped the MakerBot Conveyor Service that was denying access to COM7 (the printer's port…
-
The scaling by default does not seem to be correct with the cr1d profile. When I used the default setting my parts which should be 27mm across came out at 25.8mm. After some research and editing I hav…
-
I watched the video and readme in detail but seems I can't get it to connect to the printer.
![image](https://user-images.githubusercontent.com/37340374/38141415-ab05e85a-33fd-11e8-8570-614774d0f4…
-
Hey so I have a Qidi Tech and my friend has a Flashforge. We both use this plugin so we can connect to our printers via Octoprint and upload gcode to print. The first problem is when printing through …
-
Have a Monoprice Flashforge Creator with default firmware. Using Chrome. OP is Version 1.3.0 (master branch).
I have attempted to print from OP with the gpx plugin but the offset ?? is putting the …
-
I have been using OctoPrint with my QIDI Dual Extruder printer for a few months with no issues.
Now about 2 weeks or so ago any gcode files I send to be printed fail. They pause after a few mins and f…
-
Since 2.3.0 release I noticed my printer would not correctly start printing, as the bed would not come back up after the initial homing sequence. It worked with 2.3.0 beta, so I browsed all changes an…
-
I recently converted my Qidi Tech Dual printer to a dual Bowden extruder. I have been trying to dial in JKN Advance K and K2 to reduce the amount of filament extruded during acceleration and decelerat…