-
if i use 2 "change state" node, one for "homekit" and one from "value" but on the same "panel" the other on does not change.
like if i change one via homekit from off to on.. the on on "value" doe…
-
Thank you very much for your work on this!
I thought I'd add a note regarding decoding the status bits, both from a general knowledge and safety perspective.
In a simple 5800 installation with o…
-
Hi yozik04
Now I trying telnet interface with Arduino Uno and W5100 shield for EVOHD connection.
Have you yourself working no wirelles project for direct ethernet connection, which I can not edit c…
-
Hi There,
This is a terrific library (thank you!) and yy apologies if this is not in the correct location but I can't for the life of me figure out what my issue is. I'm using your DS3231_intalarm…
-
To make the hypnos power rail control easier, an enum system was implemented. This should be tested with different configurations of enabling/ disabling the power rails. These changes are on the lates…
-
Hello, I am building a custom cnc and it is in the final stages of wiring and configuring. Unfortunately, I am running into an error that I have been unable to diagnose for a few nights now despite he…
-
The leak detector, i think has three wires..... Did you only use two, as indicated by your wiring diagram, or did you use the vcc wire too? Did you use the 3.3V or 5V line for the leak detectors if y…
-
-
Hi,
I’m currently troubleshooting problems with my limit switches on my cnc machine. I’m getting this error for no apparent reason:
> [Error] An error was detected while sending 'X20Y-21Z-0.6I0J…
-
Hi, I have tried more and more to understande why all my IP Cameras are disconnected by AX Pro when **hikaxpro_hacs** is activeted.
I have even tried to de-active the HA integration above and no ca…