-
Do you have a wiring diagram or firmware source available? I'm starting to print and I'd rather not reinvent the wheel if I don't have to.
Thanks for the awesome project I'm looking forward to tryin…
-
Hi, currently using STM32F103R8T6.
CAN interface is connect like:
PB8 -> CAN_RX -> TJA1050
PB9 -> CAN_TX -> TJA1050
in void Setup I'm using:
bool ret = CANInit(CAN_500KBPS, 2); // CAN_RX map…
-
I try to build a Plasma cutter with a STM32F411 "blackpill" .
It skd looks like working a bit, but does not really match the expectations from documentation and source code.
The pattern is similar…
-
**.pio/libdeps/blackpill_f401cc/**RBDdimmer/src/RBDdimmer.h:21:3: error: #error "This library only supports boards with an AVR, ESP32, ESP8266, SAMD, SAM, STM32F1/F4 processor."
#error "This library …
-
PIO Core Call Error: "The following files/directories have been created in /Users/vinci/Documents/PlatformIO/Projects/3-1\ninclude - Put project header files here\nlib - Put project specific (private)…
-
Since the embedded-hal v1 is released now, it would be great to have support in FreeRTOS-rust
See: https://blog.rust-embedded.org/embedded-hal-v1/
Since it's only a dependency of the examples. I…
-
I using arduino 1.8.13., have installed the STM32encoder library and have the correct board selected, My issue is when I compile, upload the example sketches, the interrupts do not appear to be work…
va3hr updated
1 month ago
-
After being spoiled by how easy it is to flash nice!nanos, I was a little shocked by how hard it is for my new blackpill controller.
Even though these boards are not used much with zmk keyboards I …
-
I am working on programming blackpill_f401cc (WeAct) as a daughter board for Pixhawk. I was using mcp2515 for can interface and Zephyr as the RTOS. How do I go about implementing libcanard there?
-
**Describe the bug**
This issue is similar to https://github.com/zephyrproject-rtos/zephyr/issues/67227 but has to do with _board-specific_ overlays defined within a shield directory in a Zephyr modu…