-
If power is off, TARDIS should be identical to "dead" state from issue #371: no physlock, no anti-gravs, no cloaking etc.
Perhaps screen should be off as well.
Currently, anti-gravs still work if p…
-
I have remotes, bulbs, and home assistant. If I configure it using the setup in the wiki where the ESP listens to the remote, publishes the state to MQTT, then a HASS automation sends a state back to …
-
I have an Alienware Area 51 R4, which is listed as "Unknown" Tron in the "Supported and tested devices list", and hope I can provide enough info here to allow it to be known and supported.
In alien…
-
Logs growing fast using when controlling the lights using some automation.
```
2024-05-31 13:52:33.174 WARNING (Thread-2 (_start_tcp_client)) [homeassistant.helpers.frame] Detected that custom int…
-
**Describe The Bug:**
I upgraded from 2.2.0 Alpha 5 to the released 2.2.0 and now I'm getting lots of red messages in my Homebridge status log (I don't think I had these before). However, the lig…
-
```bash
ros2 topic list
^Croot@nw-ext01:/workspace# ros2 topic list
/carla/actor_list
/carla/control
/carla/debug_marker
/carla/ego_vehicle/collision
/carla/ego_vehicle/control/set_target…
-
The ACE 2000 Technical Reference Manual has come to light. This has several fascinating details. Noting a few here:
- AB ROM enabled by C079, disabled by C078, read via C022. Used by parallel firmw…
-
I’m working on a project where I need to control the onboard RGB LED (e.g., the one in the GPS module) during certain phases of flight, such as during a drone show. Is there any existing feature in MA…
-
control the light show using control center on stage
-
### Describe the problem
In some cases traffic light controls overlaps, so it is almost impossible to change state
### Steps to reproduce
1. Build similar intersection to that from screenshot…