-
The AnyTone devices cannot receive SMS if DMR-APRS reception is enabled. Quick and dirty workaround: Disable DMR-APRS RX if SMS reception is enabled in the AnyTone DMR-channel extension.
-
Yesterday i noticed that i can't write my new contactlist to my 878. It says too many contacts. But the radio can take 200.000 contacts and the file has about 160.000 contacts. In CPS i can write it w…
-
Depending on the configured bands mode the AT D878UV II Plus has different RX and TX limits according to http://members.optuszoo.com.au/jason.reilly1/868mods.htm#SelectingBands
However, the [current …
-
When I read my config from my 878UV2, and save it, I get
```
ERROR in lib/configobject.cc@304: Cannot map value 255 to enum AlertType. Ignore attribute but this points to an incompatibility in some…
-
With qdmr built from a82b6a2 I'm hitting a 100% reproducible crash when trying to read from or write to an Anytone D878UV2.
Excerpt from crash log:
```
[…]
Crashed Thread: 10 D878UV2
…
-
- Platform: Raspberry Pi 4, 4GB, Raspberry Pi OS Bullseye (current)
- qdmr: v0.10.2 (compiled and installed as to website instructions)
- Radio: Anytone AT 878-UV, HW: 1.00, Firmware: 1.21
When t…
-
Reading from a D878UV radio, FW version 1.26, 2 channels, each with DCS code 413N yields the following yaml file:
`dmrconf read d878uv.dfu`
`dmrconf decode --yaml --radio=d878uv d878uv.dfu > d878uv.…
-
The global squelch settings for analog channels in AnyTone D878UV decodes as *open* irrespective of the actual settings. Funny though, encoding works properly.
Likely affects other AnyTone devices …
-
After upgrading my d878uv from 1.24N to 1.26 I was unable to change zones with up and down buttons.
There is now a new zone setting, "Zone Hide", which is enabled by default.
![CPS](https://pi…
-
I followed the compile/install instructions at https://dm3mat.darc.de/qdmr/install.html with following errors:
```
radek@saphir:~/Downloads/qdmr-0.9.3/build$ cmake .. -DCMAKE_INSTALL_PREFIX=/usr/…