-
### Version
2.2.53
### Operating system type + version
Win10 x64
### 3D printer brand / version + firmware version (if known)
A Duet Wifi with RRF2
### Behavior
When I use the variable la…
-
I wasn't able to try this app out until after I had Android 9 on my phone. So I am not sure if my problem is that it is not compatible with 9 or if it doesn't work for another reason. It keeps askin…
-
### Version
2.4.0
_Use `About->About PrusaSlicer` for release versions_
Version 2.4.0+win64
_For -dev versions, use `git describe --tag` or get the hash value for the version you downloaded or `…
-
Rerap 2 and 3 firmware configuration data missing.
-
I was wondering if any plans to enable this to monitor prints directly from a printer running RepRap Firmware (I.e. on a Duet) without having to have a Pi running Octoprint acting as a middle man?
…
-
### What happened?
I think this might be a RepRapFirmware-specific issue?
[RRF deprecated the use of M104](https://docs.duet3d.com/en/User_manual/Reference/Gcodes#m104-set-extruder-temperature)
…
-
Assuming we have direct downloads of gcode (#49) it would potentially be helpful to allow the user to specify that the patterns be repeated after completion, or even that several patterns could be ch…
-
I'm be installing a big dipper on a mingda d2, i've connected 9nly one stepper motor for testing movements but the motor is veru loudy.
firmware version 3.4.0beta 5
-
Noticed there wasn't a devcie-specific issue for wormdingler, so I thought I'd open one to keep info in the correct place.
## Software setup
- kernel: 6.4.16 (based on config from [v6.1.51](http…
-
### Version
1.41.1-rc
### Operating system type + version
Win10 64bit
### Behavior
No ability to control WHICH fans are used...
_Is this a new feature request?_
Basically, unless there …