-
Hi, im trying to check if my setup is working.
I was guessing to check if the autotune process could be run on my Pi.
i tried screen /dev/ttyUSB0 115200 as mentioned in this post:
https://github.…
-
I bought a nano CUL, but after loading this software nothing happens.
I suspect that the pinout of the device is different from the pinout that is currently supported.
The device I have is this …
-
First of all, my complements on the amount of work done in this and in the accompanying repositories.
At home I have an Itho HVAC system which I eventually want to integrate in my home automation s…
-
I connected an Arduino with a CC1101 and evofw3 on the Raspberry on which I run home assistant (2022.12.4).
Since I just started I only configured it as follows:
`ramses_cc:
serial_port: /dev/t…
-
I connected an Arduino with a CC1101 and evofw3 on the Raspberry on which I run home assistant (2022.12.4).
Since I just started I only configured it as follows:
`ramses_cc:
serial_port: /dev/t…
-
**Description of setup:**
Evohome controller, connected to Remeha Elga Ace heatpump with R8810A1018 (Opentherm module)
Firmware version: WiFi module: 02.00.17.00, Application module: 02.00.19.33
…
-
I'm looking into using this (awesome!) software with my Orcon HRC-350 (sold to me under the brand Ventiline) through an Arduino running evofw3, and am encountering a couple of issues.
The first is …
-
Hi
I have the Ebyte E07 dev board with uart. The processor is an stm8, does anyone know how to port this code for an STM8?
-
Hi,
I bought a NanoCUL a few months back to be able to control my Evohome from Domoticz.
Have been able to discover all valve, but I'm not able to set the controller mode (normal, economy, off, …
-
I see multiple times the following error:
Pretty clear whats happening as it expects 00 - 64 at that location, but there are a lot of these errors. Could it be that 64 is not the max value?
Att…