-
### Port, board and/or hardware
rp2 port, Arduino Nano-RP2040
### MicroPython version
MicroPython v1.24.0-preview.260.g09d070aa5
### Reproduction
This particular board has a 16MBytes fl…
-
**Crash report**
[root@localhost KeyDB]# make test
cd src && make test
make[1]: 进入目录“/opt/KeyDB/src”
KeyDB was not built with FLASH. Excluding FLASH tests
Cleanup: may take some time... OK
S…
-
Can't test my own image in release yet because every time I flash to my flash drive I get a million `BTRFS error (...)` before it fully boots. I've gotten it to work when installing on my eMMC, is it …
-
### Board
ESP32-S3-DevKitC-1-N-32R8V
### Device Description
ESP32-S3-DevKitC with only USB serial cable attached.
### Hardware Configuration
n/a other than onboard RGB used in sketch.
…
-
## Introduction
Zephyr uses flash devices for image and data storage. The properties of a flash device are defined in dts and sometimes hardcoded in the flash drivers. A good operation of these dev…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
Im getting LoadProhibited when trying to initialize psram on esp32s3 causing exception at Cache_Suspend_DCache() in psram.rs
Exception occured 'LoadProhibited'
Context
PC=0x42008d0b PS=0x…
-
How to flash esp32 s3 clone using flash tool? What's memory address for it? I tried several pre compiled projects like nat, wifi repeater, rubber ducky and https://github.com/Kl0ibi/esp32_hackingtool …
-
**Goal:**
- [x] 1. Flash FPGA with cd_ip1_test2
- [x] 2. Test routine 12 with new FW - scanLoad should fire after 5188x2 cycles
- [x] 3. Restructure routine 12 so that we can program the DNN, the…
-
If the display is set to red (others haven't been tested so far), flashes of a different color will appear sporadically - blue mostly, but sometimes green flashes have also been observed
https…