-
## Issue overview
The nominal capacity reported for the fluid to fluid HX appears to be too low. In the defect file, the predefined tablular report shows 600kW, yet during the simulation the device …
-
### Describe the Bug
When building a steam engine with multiple engines on common shafts, some engines slow down faster than others (observed from the differently-coloured speed cues) when the capaci…
-
It looks like the Radical Heat Sink System (RHS) displays an incorrect heat dissipation.
For example:
If you look at the Lament LMT-2R, it has 15 Double Heat Sinks which should dissipate 45 heat w…
-
### Your GTNH Discord Username
Pilad
### Your Pack Version
2.6.0
### Your Proposal
In the modpack, the nuclear reactor multiplier is 5. Gregtech also gives a multiplier of 2. As a result, the rea…
Pilad updated
2 months ago
-
Right now we assume constant thermal conductivity and constant heat capacity. For water-ice, these vary significantly between the solid and liquid phases near the freezing temperature.
The variable…
-
I would like to add a Converter which can only be on or off.
So output flow value should be 0 or nominal_value.
Is that possible?
If not, how to define for example a pump which converts electrical …
-
### Overview
This issue highlights a discrepancy in the representation of power capacity between Open Cycle Gas Turbine (OCGT) power plants and other Combined Heat and Power (CHP) gas power plants …
-
The electrical capacity, or just capacity, of the ExtractionTurbine is not reduced when more heat is produced, but stays the same. Instead of an operation range as sketched in a), the result is an ope…
-
See forum post:
https://sourceforge.net/projects/gridlab-d/forums/forum/842562/topic/6891716/index/page/1
Basically, HEAT_PUMP mode assumes a reversible heat pump. A few lines of code would do aw…
-
See forum post:
https://sourceforge.net/projects/gridlab-d/forums/forum/842562/topic/6891716/index/page/1
Basically, HEAT_PUMP mode assumes a reversible heat pump. A few lines of code would do aw…