-
Thanks so much for writing this tool -- it's been very helpful so far!
## What did you try (include command-line arguments):
I'm trying to use pcb2gcode with my fiber laser to make PCBs. My wor…
-
Hello Guys,
I am currently building a laser engraver, two Y-Steppers and one X-Stepper.
What do I have to change in the firmware so that I can use the Auto Square function?
Thanks for Help!
-
Hi
I have a 40w K40 co2 laser engraver/cutter that uses Moshidraw and it is horrible has anybody on here done a conversion that is well documented anywhere please ??
-
Hi friend, I bought sculpfun s9 laser engraver, where the board using mks.
![IMG_20230724_135014](https://github.com/makerbase-mks/MKS-DLC32/assets/41708731/9054873d-7432-43b5-8486-03a06411b36c)
…
-
Hi,
I/m using a Raspberry Zero with a clean install of Debian Bullseye Lite and a laser engraver connected to its USB port. USBip makes a successful bind on that side.
On windows 11, after insta…
-
I'm trying to use the generated svg files of a city for a laser engraver and on some large(ish) cities the level of detail is to great. There are too many paths for the software to generate a path for…
-
I successfully flashed my laser engraver with laser grbl to 1.1f on a machine I just put together. It is a 6550 laser engraver could be an eleksmaker model. I purchased it a while ago, have no origi…
-
everything needed to use and make this is LV, except the data stick witcj needs a cleanroom and HV laser engraver for the NAND chips, otherwise it can be done in MV, why?
-
I'm having an issue with the UI on my MKS TFT35 board. I recently bought it to upgrade an existing homemade laser. The issue is that no matter firmware I upload he only UI that loads in is for a 3D pr…
-
Hello,
I have this new board and i would like to connect this card wifi with esp32 but I do not know where to find the rx tx.
Is it possible to connect the rx tx on the ofline grbl controller ?
W…
fdman updated
5 years ago