-
Hi,
I've spent the last few days trying to get to the bottom of this. I think I've narrowed it down to a combination of ABP join with OTAA registration.
I am using this updated firmware by @flhofe…
-
When joining with ABP and using low data rates (SF9-SF12), downlinks do not function; at SF7-SF8 they do. If joining with OTAA downlinks function at any data rate. This using TTN. The difference is th…
-
I was testing LoraSendAndReceive sketch with MKR 1300 WAN as node and a PyCom LoPy as "nano gateway" with The Things Network.
Pycom "nanogateway" / TTN can occur in "join accept" downlink timing prob…
-
This is probably more a question than a problem.
I have on several occasions noticed that when I attempt to sent a packet, I receive an error with the call to modem.endpacket(). I prepare and se…
-
Hello guys,
On the MKR WAN 1310 [product page](https://store.arduino.cc/usa/mkr-wan-1310), it says
> When properly configured, the power consumption is now as low as 104uA!
However I am not abl…
-
I noticed that sometimes , the while loop in the endPacket() function takes too long. I think there should be a time-out inside the loop to break. Here I wrote an example of just an idea of how to dod…
-
I noticed at the bottom left of the tool bar arduino-create-agent--> open debug console in chrome, it has a textbox and a send button. If you enter
```
list
```
It gives a list of connected d…
-
Hi, do you have a sample code for the sender and receiver you show on youtube with rfm95 in sleep mode and CAD mode?
Thanks a lot for this awesome example. 0.9mA receiving consumption is great!!
-
### Describe the problem
I have the following setup: https://github.com/arduino/arduino-ide/pull/1132#pullrequestreview-1031068976
When I start the application I see the following errors logged:…
-
__I have an error when I try to communicate two modules "error: message length does not match length"__
Hello,
I have two arduino mega 2560 connected at two Ra-02 sx1278 like this:
LORA-------…
ghost updated
7 months ago