-
The be be quiet! 14025-hf-pwm fan that Thelio uses for its intake is quite noisy, particularly when spinning down. It produces an audible "rattly" noise. I uploaded a video below. Not all speakers see…
-
**Printer type** - MK3S upgraded from MK2S
**Printer firmware version** - 3.13.2
**MMU upgrade** - none
**MMU upgrade firmware version** -
**SD card or USB/Octoprint**
Normally USB/Octopr…
-
going through the [make prints better](https://github.com/PrusaOwners/prusaowners/blob/master/How_to_make_prints_better_on_the_mk3.md) page I found this:
`You will likely fail self test until a metho…
-
**Is your feature request related to a problem? Please describe.**
I'm using Waveshare DSI touchscreen on RPi, and the only way how to set brightness is to send it a PWM signal. Currently I'm using f…
haplm updated
3 years ago
-
This issue is the collection of the compatibility feedbacks.
Please leave a comment here with the name of your Super Micro motherboard if you either :
1. successfully executed SMFC
or
2. yo…
-
Wiringpi is now discontinued, and can't cope with Debian bookworm.
Here is the error I'm getting when I try to run `pwm_fan_control2`:
```
source .env && sudo -E bash -c './pwm_fan_control2'
Start…
-
I have connected a case fan to the 12V port on the board, (not the modules), to use as a passive cooling, and it's not working. the thing is there are nothing on the BMC to see the fan or temp status.…
-
Hi, may be you can help:
I've installed your cm4io-fan - basically it works, but somehow the fan speed seems to be wrong.
In my /boot/config.txt I have the following line:
dtoverlay=cm4io-fan,min…
-
In the following lines
https://github.com/vmatare/thinkfan/blob/6f294483da5c426f1bee0eb7f46302113aca51e9/src/drivers.cpp#L196-L198
Thinkfan tries to open and write to `pwmX_enable`. However, not…
depau updated
3 years ago
-
I own a R550 with an iDRAC 9 running firmware 6.0.30.0. The script does not work and the error returned is: Insufficient privilege level.
Is there any way I could downgrade to version 3.30.30.30 (…