-
Hi.
Is there a chance to make a choice how many values within an output configuration is send to a controller ( 1-4 ) ?
I'm having difficulties in domoticz to receive data through an idx value and h…
-
Hi! Is it possible to display a metric that shows how much power the solar panels produce?
-
I was trying to connect PZEM004 to Arduino nano 33 IoT board, and this library is using SofwareSerial.h,
I tried to dig deeper, and Nano 33 IoT does not use SoftwareSerial anymore, so I'm not sure ho…
-
> Im using PZEM004t-100A(V3). Im using RX (3) and TX (1). Connected to an AC load and all wires are connected properly. Even the readAddress() is not functioning. I saw in the data sheet…
-
**Describe the bug**
Hi, im new to arduino, here i want to measure power and energy from my sensor.
The measurement only return voltage value, while i need the power and energy measurement.
im wiri…
-
I have a triac-dimmer circuit like below with load is incandescent lamp, when i connect the N and L to 2 terminals of lamp, they cannot dim and work at max power - maximum brightness althought i just …
-
### The problem
Hi;
Lately, a lot of projects are coming up using 2 or more pzem..
It's my case, I'm using 9 pzem with 1 Nodemcu...
Now it's working correctly, but, during programming, the d…
-
```
jeedom@jeedom:/var/www/html/plugins/pzem004tv3/3rdparty $ sudo chmod u+x PZEM*
```
Si install depuis market le droit x n est pas en place.
-
### The problem
If (after working fine) suddenly the PZEM-004T stopps sending data (e.g.: the AC power of PZEM-004T is interrupted) then ... nothing happends: the last value remain active as if every…
-
Bonjour. J’ai acheté le plugin sur le market Jeedom. Jeedom tourne sur un RPI 1.
Le plugin ne remonte aucune info du PZEM.
pouvez vous m’aider?