-
Hi,
The Scratch extension seems to switch on the integrated Pulldown resistors on Arduino input pins. I am working on a project with sensor contacts like MakeyMakey http://www.makeymakey.com/. There I…
-
Do you suggest we always install a termination resistor on the board side? Why was it not included on the board?
Thanks!
-
Did you read these resistor values from a properly working Hybrid? or was it an unknown one?
Because if not, then chances are those resistor values are going to be wrong, and will need cross-check…
-
_From [stefanhermann79@googlemail.com](https://code.google.com/u/stefanhermann79@googlemail.com/) on September 28, 2012 03:36:57_
It would be cool, if Fritzing would have a resistor calculator widget…
-
As we were trying to solder the 150 Ohm resistors, we discovered that we only have 1210 resistor type and no 1206 of 150 Ohm.
-
A resistor in series with an AC source, when the resistor's terminals are adjusted, can cause the signal to be inverted by 180 degrees. This may lead to confusion for users when simulating related ci…
-
One question, is there already a script for generating the 3D model of SM series resistors, see here: https://www.te.com/commerce/DocumentDelivery/DDEController?Action=srchrtrv&DocNm=1773242&DocType=D…
-
TIMER_DONE - Pull down 10k
TIMER_EN_5V serial 470k
RTC_EN_5V serial 470k
serail inline ENABLE_5V
-
timer resistor R31 to 170 Ohm
-
What should be the resistor configuration for r1-r8 if TLCR5800 is used along with BPW96 instead of SFH4550 and TEFT4300 emitter and transistors in the wall sensor advanced board?