-
Hi,
I flew a new model RS41 today , forgot to set the txpower to stage 5 so the battery appeared to drop quite quickly.
Last report after burst was at 1.92 Volt.
The batteryCutOffVoltage is set…
-
Maybe I missed something, but I couldn't spot anywhere in your code where you are setting the dynamic model of the uBlox GNSS chipset.
If you don't set this to one of the airborne dynamic models (I r…
-
**Describe the bug**
I'm observing a lot of DFM radiosondes from the Calw military area.
From time to time there seem to be some position glitches causing the sonde to jump >100km.
(RS41 is h…
dm5tt updated
2 years ago
-
Hello,
the altitude decoded is wrong
try this morning, displayed by portapack => -48m (yes minus)
decoded by software PC => 195m
So the batterie voltage is wrong too displayed 578.000 mV ????…
F4GEV updated
5 years ago
-
In order to compile either or version, you have to change lines 16 and 17 in the rs41-nfw_v21.ini file depending on your choice what the compile.
//#define RSM4x4 // select this fot new pcb ver…
-
The operating frequency of the MRZ-N1 weather balloon is very stable in flight, no worse than the RS-41. Please add to the calibration of the MRZ-N1 receiver.
thanks
-
Hi,
Today I succesfully followed the instruction to progam a next generation RS41 with self compiled firmware in the Arduino IDE. I used the stm32 programmer tool to flahs the compiled binary .
B…
-
V1.4 image, DOA is working fine at 853.85mhz (antenna array supports 700-1700 mhz). If I change frequency to 1.680 ghz, the config shows errors (see photo) and won't recover without Software Restart.
…
-
Hello,
What modulation is supported by this firmware for APRS?
-
**Describe the bug**
The SX1268 does not turn on. The serial output shows that communication with the chip does not occur, as the frequency setting nor gain settings at startup apply. Additionally it…
mph88 updated
10 months ago