-
rtl_433_mqtt_hass.py skips the Consumption key for SCMplus devices. A quick fix would be to copy the "consumption_data" mapping to a new "Consumption" mapping.
-
I had to rebuild my image that collected the Meter data and for some reason I am no longer getting data for the water meter., When I run rtlamr with the msgtype=all It picks up the meter with this ou…
-
Have you looked at implementing a matched filter to handle the manchester coding in signal processing rather than after you've done bit-decision? You can avoid having to set any kind of signal strengt…
-
I'm not quite sure what to do?
INFO: Registered PHY handler 'UAV' as ID 4
INFO: Registered PHY handler 'NrfMousejack' as ID 5
INFO: Using default rates of 10/min, 1/sec for alert 'BLEEDINGTOOTH'
…
-
This is with Docker Desktop on Mac OS. Logs output:
`
Sending message to MQTT:
> hostname => 192.168.0.6
> port => 1883
> username => homeassistant
> password => *** REDACTED ***
> topic…
-
First, I know next to nothing about Go, so I'm probably doing something wrong. But I can generally follow instructions :)
Installed Go with `apt-get install golang-go` on my Debian x86 box, which i…
-
Don't disagree on the consistency thing, but it's coming through as hex in the raw log stream from rtlamr. I don't think the new merge is picking it up...
```
{Time:2024-07-01T19:03:01.053 SCM:{ID…
drum7 updated
2 months ago
-
INFO: Data source 'mousejack:name=nRF,hop_rate=82/sec' launched
successfully
INFO: Data source 'freaklabs:device=/dev/ttyUSB0,name=freak2,band=2400,hop_
rate=32/sec' launched successfu…
-
Hello, ive been trying to start kismet for 2 days know. I surfed the whole internet but can't find anything that could help. If i start Kismet, that is my output:
INFO: Including sub-config file: /…
-
All documentation I've seen on the iTron ERT protocols state that they are FHSS, however I don't see any evidence of handling frequency hopping in rtlamr anywhere (but maybe I haven't fully understood…