-
I'm trying to setup Linear Advance / Pressure Advance.
M900 is not found and the linear advance calibration pattern lines look all the same.
I'm trying to find out if the K-Factor settings in …
-
Got sensorless homing working fine with FYSETC TMC2240 and the following config:
[tmc2240 stepper_x]
spi_software_mosi_pin: PB15
spi_software_miso_pin: PB14
spi_software_sclk_pin: PB13
cs_pin: P…
-
### Wiki Search Terms
TNC driver not detected
### Controller Board
6-pack
### Machine Description
Dual Y, X, Z . Nema 17, 24v. TMC2130. x 6
### Input Circuits
_No response_
### Configuration …
-
### Controller Board
6-pack, running v3.6.5-pre4 with index.html.gz updated from the same pre release
### Machine Description
Gantry router
### Input Circuits
_No response_
### Confi…
-
#####################################################################
# Extruder
#####################################################################
# E0 on MOTOR6
[extruder]
step_pin: EBBCa…
-
I found that there is no way to change the print head auto-parking code.
I tried to do this this in "GCODE" page, GcodeID = 8031, and I changed the line to mine (I need this workaround for some reaso…
-
### Wiki Search Terms
https://github.com/bdring/FluidNC/issues/1201
https://github.com/bdring/FluidNC/issues/1008
https://github.com/bdring/FluidNC/issues/1001
### Controller Board
![SCH_SCH_MAIN…
-
Hello,
Unfortunately I can't find a solution to the problem mentioned. The printer works so far (leveling etc.) but when I try to print I get this error: Move out of range: 0.000 -0.000 388.236 [0.…
-
Slic3r 1.3.0
**Is your feature request related to a problem? Please describe.**
Many TMC stepper drivers feature an UART/SPI interface that allows on the fly motor current and operation mode (Stea…
Quas7 updated
4 years ago
-
Hello, I have "Global scaler" communication problems with various brands of TMC5160 drivers. In the examples, there are some pins in the table, there are others. I have tried several combinations and …