-
I am trying to use the UART async API on stm32f7. It works nicely up to about 460.8kbps, but above that I start loosing characters during buffer switch. I immediately provide new buffers when requeste…
hjuul updated
9 months ago
-
I sucessful use FF with an 26-pin header Gotek Floppy and use it in my Tektronix TDS3000 series (TDS3012B) Oscilloscope. The PB and the LEDs are at the same pins. I have to remove the resistors RA & R…
-
I recently added initial support for Renault batteries, but this needs to be tested extensively. Please contact me if someone here is planning to use these batteries!
https://github.com/dalathegrea…
-
**Describe the bug**
RNDIS example PR #287 may not work with all ports, following is port that work
- Microchip SAMD
- Nordic nRF52840
- Nuvoton NUC126
- Nuvoton NUC505
- STM32 FSDev
- STM32 (…
-
I'm aware of the OpenFlops project (stm32f105-based), but wondering if there would be any interest in a design using the more capable F435 part.
I'm thinking of something that could be shared on e.g.…
-
After updating from 3.5 to 3.6 my custom boards aren't found anymore. My setup is as follows:
```
── zephyrproject
│ ├── apps
│ │ ├── app1
...
│ │ ├── boards
│ │ │ └── arm
│ …
-
Some printers' boards, such as for instance the Creality Ender 2, don't have RX/TX GPIOs for serial communication, which means this project cannot be used with them. As these are mostly inexpensive pr…
-
Hello keirf,
I converted my Philips VG-8235/22 MSX2 computer to 720k with Gotek Artery AT32F435. I have the latest firmware on it and set host=msx in the FF config. The 720k images finally work gr…
micv2 updated
9 months ago
-
An async I/O discussion started at https://github.com/keirf/FlashFloppy/pull/412#issuecomment-753576777 . It was an idea to free up a lot of memory from write_bc, allowing it to be reused for reading.…
-
**Environment:**
Korg I30 with Gotek [SFRC992D/ARM STM32F105] and Flashfloppy version 3.41.
Jumper on JC and S1
interface = ibmpc-hdout
Host = akai < [due to information on https://github.com/keir…