-
Fine wire thermocouples to be used with sonic anemometers should have a better reference temperature measurement than the logger panel voltage
-
II am trying to use a K type thermocouple and am having no luck with getting correct readings? I am using and Azteeg X3 pro board and have set Temperature sensor as AD595 as recommended by Roy at Panu…
-
Hello,
I have the exact same setup as you did in your video, but my meassured temperature lags behind significantly.
My best guess is, that my thermocouple takes way to long to meassure the actual t…
-
### Duet Forum Discussion Thread
https://forum.duet3d.com/topic/36729/deadlock-reading-the-object-model-from-a-plugin/10
### Which Duet products are you using?
- [ ] Duet2-Wifi
- [ ] Duet2-Ethernet…
-
So, I think this is to do with the fact that the libraries have changed in the last 3 years. When I started messing with the controller firmware, this started when I re-flashed the latest version in `…
-
I was informed (and I should also know this from lectures...) that we have to be careful with the readings from the thermocouple regarding its cold junction temperature.
Small excursion to the world …
-
When running with sim mode, the temp reaches the target and never resets, disallowing running another simulated schedule without restarting the service. I would propose one of two approaches - either …
-
We have a MCP96L00T thermocouple amplifier connected over the I2C0 bus. This module should report temperatures coming from the amp, and also be able to set the thermocouple type. The amp will require …
-
The TLC27L2CD has an iput offset of max. 10mV. For example the voltage at the thermocouple pins at 245°C is approx. 10mV! This could be somehow compensated by the calibration potentiometers but it is …
STB3 updated
2 months ago
-
Hello! Pretty new to Arduino's here but I am using one for a school project to monitor surface temperatures using a K-type thermocouple and an Adafruit MAX31856 Universal Thermocouple Amplifier. I am …