-
Issue reported from Round ID: 7665 (NSV 13 | Official | MRP | 98% Free Lag | Spaceship Combat Server)
Reporting client version: 515.1641
On round 7663 in NSV Snake I made a flight to Veneto and…
-
Hello,
I appreciate all the hard work you've put into this!
I've been printing the Interactive BOM list, taping the parts to the paper, and then I assemble it from that. It works great! Assembl…
-
**Team Objectives:**
- [ ] Finish building a robot that is able to do every component of the game
**Team Member Specific Objectives:**
Ella:
- Finish testing the alliance specific autonomous …
-
**Links:** https://www.wowhead.com/quest=26552/through-the-troll-hole
**What is happening:** Upon going through the portal, the quest isn't getting completed.
**What should happen:** Once the us…
-
When uploading eseRC755 - Drill Ident Drawing - [Through Hole].gbr to PCB print it gives an error.
This file should be compatible with Gerber RS-274x. Please, review it or upload compatible file.
…
-
### What is the issue?
I discovered that Tailscale does not resolve my DNS requests as expected (through my pi-hole which is set as the only Global Nameserver) if I use an exit node where "accept-dns…
-
Hello,
I found that if the relay node is physically close enough to the nodes that under the NAT device, an error "failed to open hole-punching stream: failed to negotiate protocol: protocols not sup…
-
I went deep through the rabbit hole of uncertainty quantification in forecasting of neural networks. A faster method of quantifying uncertainty than what was proposed by [Lapeyrolerie et al, 2022](htt…
-
-
I'd love a parameter to add holes in the lid, either to fit a small tube/straw through or many small holes to make a shaker. I've played around with trying to implement this but haven't got anything …