-
1. The documentation said that S42C supports UART for communication, but where do I connect it to? Where are the Tx and Rx pin?
I'm writing my own firmware so I need to know this.
2. Second, the p…
-
Hello @leodesigner. First of all, I'd like to thank you for your work on reverse engineering the communication protocol of PowMr 4500/6500 inverter.
Unfortunately, I'm facing some issues when commu…
-
hello. recently I noticed that several times a day the data from my JK BMS + esp32 via UART is lost...searching on the Internet says that this is possible after updating ESPhome itself...
here is my …
-
## Summary
Using my forked checkout of the latest master (801c0d66323a90029889c96f8a894072b5831c46) I setup two Faraday radios and ran proxy connected to both of them. They were only sending out UART…
-
Hi,
I've just done a similar project myself, using an ESP32C3 mcu, and came to roughly the same solution as you....
However, I used 7N1 serial. ( which is 1 start bit, 7 data bits, 1 end bit), …
-
**Describe the problem you have/What new integration you would like**
Integration for Modbus protocol for Daikin controller series FWEC.
**Please describe your use case for this integration …
-
## Feature request
**Is your feature request related to a problem? Please describe.**
I have a Navio2 RPI Hat. While trying to set up Remote Control for the hat, I tried connecting my ELRS recei…
-
Let's run a number of manual tests and additional checks in order to make sure v0.6.5 will be the best release ever.
Test binaries can be found here: https://github.com/bettio/avm_tag_ci/releases/t…
-
Hi.
I have two batteries connected in parallel with an RS485 link.
First one is set to address 1. Second one is set to address 2.
I have connected one esp32 to each one.
The one with address 1 w…
f3nix updated
3 weeks ago
-
### What happened?
Occasionally, the port on my Zigbee dongle shuts down (one to 5times a day).
When this happens, restarting the service consistently causes Home Assistant to crash, resulting in …