-
Hi!
I have a Controllino Mega, and im trying to enter configuration menu to set and store my own parameters after sucessfully sketch upload, but when I short RXD2 to ground, i receive "invalid sign…
-
This chip is found on an IPC-RB-BLK530AI board (IP camera), which I took apart to read its name and tried to dump.
I can't read from the chip too reliably while in circuit. I mostly get the message…
-
Hello
I am trying to use the sketch Arduino_Wifi_AVRISP, together with avrdude without success.
My setup:
Windows 10
Avrdude 6.3
Wemos D1 mini connected to Arduino Pro Mini:
ESP ProMi…
-
Did you delete your python script from this repo? Does this layout/wiring work? I'm thinking of using this for programming an Attiny on my Raspberry Pi connected PCB.
-
Hello
I'm frank, has big problem for uploading grbl v0.9 or over version.
I was used my CNC machine as v0.8 version, Hence I decided upgrade as v1.1
However, Arduino nano board can't upload v0.9 …
-
Burning the MiniCore bootloader does not work with the M3 MacBook Pro. I believe this issue may be caused by the USB-C to USB adaptor or some other hardware issue on Apple silicon. Previously, I was a…
-
```
Most of the XMM cache drivers and the library SD card access routines use
either the SPI or I2C bus. These agents just grab the bus whenever they need
it, with no regard for any asynchronous ag…
-
Using a Mac, Have Arduino IDE 1.0.6 which i believe is the last one, and Brackets says it's up to date.
I Installed extension via extension manager option, the boards drop down just say loading... …
-
Using Arduino IDE 1.6.10/Arduino AVR Boards 1.6.12 with Windows 7 64 and 32 bit
1. Select **Tools > Board > Uno** from the Arduino IDE menus.
2. Select **Tools > Programmer > AVRISP mkII** from th…
-
Just to throw my two cents here.
First of all - thank you @chamnit for making this software! It makes building amateur cnc a snap and dirt cheap! You should have a monument somewhere (cnc milled o…