-
## Bug Report
So I'm a redis/lettuce n00b, and I may be missing something (probably am), but I can't get redis with sentinel (not Redis Cluster) to function 100% on failover.
#### Current Behavi…
-
Looking for a quick connect option for the new Mastercraft batteries we are going to be using. See part number 2823492000 Wiring Harness Assembly.
-
Hi,
I have a Chinese Laser cutter and I am planning to use GRBL_ESP32 controller for it and i have found it very hard to find any documentation on how to connect the controller to the laser PSU. I kn…
-
### Description
branch CrealityDwin_2.0
running on CR-10S Pro
looks like the firmware is not considering the state of the Filament sensor
### Steps to Reproduce
1. remove filamen…
-
### Description
BL Touch new 3.0 units not working with marlin on homing. Probe responds to M codes for deployment, stowing, and shows no errors, but when it comes to levelling the probe doesn't se…
-
this is the old wiring harness not the new one
https://promega.printm3d.com/maintenance-guides/changing/changing-extruders
-
[Per a comment](https://www.reddit.com/r/rust/comments/7rb072/oxidizing_source_maps_with_rust_and_webassembly/dsvu3x0/) by @epage on reddit: How can a library author ensure that their library can be u…
est31 updated
5 years ago
-
Right now, there is no way to shut down the Nextcloud Box without going in with SSH and running shutdown manually. That is a problem as we don't want people to have to do that.
Just pulling the plug …
-
hi , i have bought an cable from ebay an uses you software , i had the ftdi already installed and it runs fine .
it sets the com port to Com2 and is shown in your softwre.
i turn on the ignition , c…
-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…