-
then I flash 1.8 and 1.7.3 ，I2C works will
-
As the subject already says, the current version of cleanflight is missing the MAG which was detected by older versions of cleanflight.
I don't know if i want to use it but in the near future, but i …
-
Hi,
today i tried RC2, however i am unable to arm, normally i arm with AUX1, after this didn't work, i tried to arm with the left stick (MODE 2). Doesn't work either.
Here is the dump of my settings…
-
Flashing my BlueJayF4 revision 3 with iNav (1.7.2) makes it unusable and one has to use the boot button to reflash it (back to Betaflight). It doesn't respond on the USB port (i.e., there's no `/dev/t…
-
As in the post:
I have a Naze32 rev6 10DOF (with compass). Athough CF sees that it is present (an icon in Conf-tool) however it seems that it does not autodetect the correct hardware. setting hw type …
-
I'm having issues with flying in MAG mode (which now should trigger heading-hold mode).
1. The feeling is not good for me. When I try a subtle yaw correction in a stable flight the quad actually re…
-
Hello,
first of all....excellent work.
Will you port it to latest TM4c129x Tivaware family?
Regards.
-
arf3 3.1 dshot can not work
According to f3evo re-made the target
but Motor2 not worl in dshot,multishot is ok
target.c:
`#include
#include
#include "drivers/io.h"
#include "drivers/time…
-
I'm having fishbowl effect on this setup (see title). It happened first a year ago on iNav with different frame, etc. Now, I took same FC and put on brand new frame and it's happening again. 6" props …
-
this is the status and bootlog
# status
System Uptime: 32 seconds, Voltage: 0 * 0.1V (1S battery - NOT PRESENT), System load: 0.01
CPU Clock=72MHz, GYRO=MPU6500, ACC=MPU6500
Sensor status: GYRO=OK…