-
Hello
In my setup I intend to switch the 48V to the TMC5160 drivers on only when needed, so when i boot everything up VMot is 0V. Under these conditions autotune will cause an error and will make …
-
In the driver type section is it possible to add an option to select a define method as External or Mechaduino as with most onboard drivers they use 4 control signals STEP, DIR, ENABLE and CS
As ex…
-
I want to connect 2 TMC2209 to arduino ,
when i send 1 in serial just one stepper worked wich have address 0b00 the otherone with ADD 0b11 not worked , however MS1 MS2 with Vio for Add 0b11
this…
-
Changing in grbl library for add a feed back(close loop stepper motor) to measure a rotation of stepper motor for precision using a encoder. Please any one can make this change it is very important.
-
This may be a non-issue, since it happened after using it to power a stepper motor driver for a NEMA17, but the LED arrays don't flash when the controller board is turned on - instead, the one LED sta…
-
# Microstep Shift in Z-Axis Probing
## Issue Description
During Z-axis probing operations, there's a consistent microstep difference between the trigger position and the halt position that should …
-
n this dual XY core and common Z configuration, you'll need to control the independent XY movement of both print heads, which requires additional stepper motor drivers and pins. Additionally, you'll s…
-
Hi Derek,
Sorry this is not an issue as such, but more of a bunch of questions!
I came across this great project via the Indilib forums when I was searching on DIY focusers. I had been intending…
-
[FR] Single Nozzle, Shared Extruder Stepper, Single Servo, 8 Filaments
Hello, I have an FDM 3D Printer with 8 Filaments selected by one 300 degree hobby servo and one shared planetary geared extrud…
-
Hi I cannot seen to get the simple example to compile I get the following error
use of deleted function 'TMC2208Stepper::TMC2208Stepper(uint16_t, uint16_t, float)'
0; i--) {
digitalWrite(…