-
- [x] Make nodejs compile & work
- [x] Add signalk to Venus images
- [x] Pre-configure N2K connection on Venus GX
- [x] pre-configure signalk-venus-plugin to be installed & configured to dbus on l…
-
Are there any specific instructions for installing the requirements on VenusOS v2.85? I'm getting an error saying that pycairo can't be built:
```
$ pip3.8 install pycairo
Collecting pycairo
U…
-
Hi,
I was wondering if I could run this on a Cerbo GX instead of the Pi? Any disadvantages? I have a pi here but I have also ordered a Cerbo GX. Wondering if I should return the Cerbo... However Th…
kLOsk updated
2 years ago
-
My current BMS can either be connected to BT or Serial connection to VenusOS. I get to see all cell voltages in BMS , but would like to have the BMS sending the low and high cell to the VenusOS to co…
-
I noticed that influxDB sends records in a v.rapid succession.
Having VenusOs already sending data to a separate influxDB at 60sec intervals (configurable at the gui) which are then viewed in Graphan…
-
trying to understand the code and see how I can get TCA6408 to read the Input A B C D (and then pulse RE2 as per #121 )
anyway, considering that there are two push buttons on my 4.3 controller PCB …
-
I gather from the recent changes a new tool called SetupHelper, currently in beta, is going to help 3rd party add-ons like 123 SmartBMS properly integrate themselves into the initial setup and update …
-
**Describe the bug**
I am using a newer DALY BMS 4S12V, which can only communicate to the DALY PC Monitor, not anymore to Sinowealth.
In the parameter section of the remote console the following is …
-
hello,
over at https://github.com/Louisvdw/dbus-serialbattery there's a pull request (just approved whilst I was typing!) for sending all cell voltage balance status as well as diff from highest t…
-
Check compatibility with VenusOS 2.80
In Venus 2.80, the rootfs is now read-only. To install the service, you need to remount it rw (which you can do with the script /opt/victronenergy/swupdate-sc…