-
@peter-michalski, I'm hoping that you can help me with the domain expert meeting slides. I'd like them done by the end of the day tomorrow (Thursday) and I don't think I'll be able to finish them on …
-
@cjbe @WeiDaZhang and I have been looking at the timing stability of DRTIO on Kasli (all comments apply equally to Sayma of course).
Expectation:
E1. The latency between TTLs on Kasli DRTIO slaves…
-
As a first benchmark for 2D measurements try to produce binned pTH in nJets bins measurement.
In principle it's still a "1D" measurement, where we use as gen/reco observables a cut on both pTH and …
-
The HX711 load cell ADC is used as a bed level sensor on the upcoming [Creality CR-6](https://www.creality.com/cr-6-se-3d-printer-back-us-to-save-100-p00296p1.html) series of printers. It works by tre…
-
Maybe before DD, maybe circa DD release:
* Done ~openDrain, openDrainFast - as currently implemented on megaTinyCore, unless someone screams about problems there.~
* pinConfig(pin,uint16_t) - omnib…
-
Hi there,
Very good calibrations pages. And first thanks a lot for this !!
Maybe an useful other calibration test is for X,Y and Z steps motors. => M92 + M500
With xyz cube or other xyz calibra…
-
Hello!
I was wondering how to explicitly specify that my input variables are numeric (continuous) rather than categorical?
In the examples, songbird multinomial defaults to variables being nume…
-
From the TRF data-sheet and the Phaser schematics it looks to me like the MMCX LO output should be at +3 dBm. However, I only get -27 dBm. Is this expected?
Data-sheet and phaser schematics:
 were introduced to solve a bug in `Source._set_temporarily`, in which the parameters were not reset properly after being call…
-
As title when i issue G28 all is ok. Test with paper passed (some friction).
after send G29 the nozzle is higher than it should be. The same paper pass freely between the nozzle and the bed.
I don't k…