-
I can't get smartport telemetry work over softserial in spracing f3 evo.
RX and TX are shorted and connected to motor outputs 7 and 8. Tried flashing both targets, SPRacingEvo, using Softserial2 an…
BbypK updated
7 years ago
-
If a flight controller hangs mid-flight many bad things can happen. A watchdog timer would be very useful for rebooting a FC in such case. STM32's backup SRAM can be used to hold current system state …
-
Cannot get the acc to recognize any axis of the 6 step calibration procedure. Is this possibly a firmware bug?
-
My micro quad is drifting to the right in ANGLE and HORIZON mode. It gets stronger over time until I really have to fight the quad hard not to drift. As you see in this video the drift grows over time…
-
I recently damaged my original UBLOX gps and had a NAZA GPS clone laying around so I thought I would use that instead. I have built the firmware for my Naze32 Rev6 to include the NAZA protocol. I seem…
-
Hi,
I have a freeze problem
Hardware: SP F3 EVO, Graupner Hott GR-16 receiver
Software INAV 1.7.0
If I connect the GR-16 Hott telemetry with the diode to the FC (Flight Controller), the contro…
-
@martinbudden
i think your latest #1757 brakes the change of gyro update frequency ... No matter what I set in configurator it always runs with 1khz :(
cli outputs:
```
Entering CLI Mode, type …
ghost updated
7 years ago
-
Among other
- Read data form sensors
- Display on Sharp Memory Display
- Send and receive through BLE
-
If i set gyro update and pid loop at the same frequency, smart port telemetry stop working.
i've tried 2k/2k 4k/4k 8k/8k
If i set 4k/2k 2k/1k 8k/4k smartport telemetry works
I use a spracing f3 evo w…
-
i flashed a revolt f4 with 3.1 everything works fine until takeoff. I have everything on correctly(props) and motors spin right way. Using mixer quad x 1234 and wired esc's as setup on revolt. Quad…