-
**Is your feature request related to a problem? Please describe.**
In areas with congested WiFi (such as urban areas with 70+ APs), pure wireless based data transmission can suffer from packet errors…
-
**Describe the solution you'd like**
I like the 2D GEQ graphic equalizer effect, but what i'd really like is a mirrored version - so the lowest frequency in the middle, with higher frequencies to ea…
-
Fixed (thanks Bart!).
Installed FluidNC 3.2.8 firmware, Wemos D1 R32 ESP32 board (ESPDUINO-32 HW -729), wifi and WebUI starts instantly. Everything is fine! When connecting motors (NEMA23 2.8A) an…
-
### Description
I was running two `DS18B20+PAR` temperature sensors without any problems for the last two years on an ESP-01 module running on 3.3V using a 4.7K pullup resistor.
Now, wanting to de…
LeoDJ updated
2 years ago
-
Hello,
first i want to thank you for this great project. Realy good work!
I'm trying to use the opentherm master shield with a wemos d1 mini from diyless.com with a remeha tzerra ace boiler.
Th…
-
Hi there..
I live in India and I do not have access to your ESP32 board.
I have GRBL Plotter (AxiDraw Clone) running well on UNO with CNC Shield V3.
I am wondering if your firmware can be configur…
-
Greetings, first of all great job with this new 42C version. HW wise looks pretty good.
Would it be possible to release the schematic and if not the full schematic then at least the input part with…
-
I am not able to remain connected to WLED hotspot when it runs on 12vdc. If I keep my phone less than 6" from the ESP32 it will stay connected, but any further it will disconnect immediately. WLED is …
-
I am seeing plenty of failed builds recently and the only cause I can put a finger on is rebuilding IntelliSense index.
When I hit Build (menu or button), PIO starts build process but after a secon…
-
Hi,
I can't find this anywhere on the internet whether Tasmota on Sonoff basic would support the a door opening sensor on GPIO14, but **without impacting** the state of relay (use GPIO14 just for rep…