-
I am interested in comparing a few different slicers using octoprint and m33fio. I would like to know what m33fio does if you send octoprint gcode instead of slicing using cura engine. What about ba…
-
Dear Luc!
I've changed to a E3D V6 bowden extruder on my Davinci and now do a lot of trials for new temperature and volumetric setting. For these trials I found the "load filament" function very usef…
Hecot updated
8 years ago
-
i carnt print online as the option to online print dosent pop up
-
I'm trying to use OpensCad to convert PCB DXF's to extrudes and trouble. OpensCad will open KiCad DXF's without an issue but that's the only program that OpensCad can open DXF's from (effectively). …
-
Im trying to flash via the directions here:
https://github.com/luc-github/Repetier-Firmware-0.92
Im a bit confused by step 4:
""""Update variants.cpp arduino file with the one present in src\Ardui…
-
I just ran two test prints using V 0.7, and with both prints the Filament usage showed no data.
If I expand the print file to show more info in the File library however it does correctly show the fil…
-
Comparing the GCode output of CURA V13.03 with Skeinforge files which I sliced before and which have printed successfully, the values of the extruder travel seem extremely high which explains the mass…