-
I have a BetaFPV Micro TX 2.4g and taranis x9d (not the new 2019 access version)
at 400k baud rate and 500hz refresh rate everything works fine but f1000hz says baud rate too low but when i increas…
xgg69 updated
2 months ago
-
Instead of just try-except pass around error messages to report back. Also for transactions that fail. Also for file system errors.
This is non-trivial.
Kindly report use cases (including API) whe…
-
The ER3C-I 3ch PWM Receiver 2.4GHz goes to 988 PWM when turned on. I assume thats a hardware issue. but is that something you guys can look into?
-
This is a list of known issues especially blockers for the 4.1.0 copter release. (also see [Rover-4.1](https://github.com/ArduPilot/ardupilot/issues/17116), [Plane-4.1](https://github.com/ArduPilot/ar…
-
Is there a failsafe setting ?
I cannot get my FC into failsafe mode.
-
Need to remove security key from App.py, will need to establish a new key as well
-
Recently tried the 3D flight mode, using firmware 0.4.1, there was no problem when testing at the configurator (accurate steering And the direction of thrust is correct), and the forward flight was no…
-
As we come closer to the due date, and while we wait for the allocated components of other members, i wanted to address another major area we need to begin addressing to better secure our website. Som…
-
This is a front-end requirement, not well understood yet, but not anticipated to be complex.
-
### Describe the bug
I monitor to UART1 TX without any data when T1 was configured as Smartaudio, but when changed to IRC Tramp kept receiving some data, but I didn't confirm if it was correct or not…