-
When I upload GCode to my Duet Wifi with this plugin the settings that Cura appends at the end of the file will not be saved to the SD card. The file will end with
```
; End of Gcode
```
If I save…
-
As a soon-to-be owner of a duet wifi and newby of reprap firmware, I am planning to design a tool-switching corexy 3d printer.
For that reason, I would love to have the ability to measure and set the…
-
Hi! I love this plugin. Is there any chance it can be extended to control a Duet Wifi board? Thanks.
-
So, I just did a few upgrades to my V2/V3 Hybrid (Titan extruder and a PT-100 temp sensor) and I figured I'd go for a firmware update while I was at it. I ran through the Repetier Online configuration…
-
I'm fairly new to all this, so it might be something on my end, but I can't figure out what I could possibly be doing wrong. I'm running Cura 3.3.1 on mac os x 10.13.4 and I've got the plugin installe…
-
I can not get the Winstar LCD on a DaVinci serial number starting with 3F10A working. The upload seems to go fine but no joy with the LCD. It has the back light and the 2 black bars but no characters.…
-
#### If this is a feature request describe it here
FEATURE_REQUEST_DESCRIPTION_GOES_HERE
#### Version of Octolapse
Octolapse Version: Octolapse Vv0.3.0rc1
#### Version of OctoPr…
-
MacOS Sierra 10.12.5, BOSSA GUI looks like it starts but then just exits without doing anything. this is with the supplied version 1.8 DMG from the releases.
Hardware is Early 2015 MacBook 12 usin…
-
Nice to be able to power up the printer and see right away on the Panel Due the IP address assigned to the underlying Duet or Duet WiFi. Yes, it can be found by going to the console and manually ente…
-
as per subject would it make sense to update Ramps FD ? are there any improvements that could be made?