-
Flashing the latest hex gets the board stuck in dfu mode. Then it's no longer recognised by the computer and can no longer access the gui. Only way back is by reflashing Cleanflight then it works norm…
-
### Problem
on my Naze32 with oneshot125 activated I have poor motor power at full throttle. without oneshot everything works fine. I recognized it after update from v2.4 to all versions > 2.5.0RC7.
…
-
During target testing I discovered that my COLIBRI race board doesnt boot with 3.0 firmware. It does work on LUX_RACE firmware. THe hardware is same....colibri just has some extra stuff
-
Hi Boris,
First thanks for your amazing work !
We are designing a new board and we need your help.
The Sp racing F3 used the MPU6050, compass is 5833.
For our new board we use the MPU9250=MPU6500+A…
-
Until this is fixed disable the mag on the SPRacingF3EVO using the following cli commands
```
set mag_hardware=1
save
```
The issue can be seen in the GUI too - the looptime will occaisionally jump …
hydra updated
8 years ago
-
*Issue help please,
been flying fine since my build around a month ago
until now I'm getting a strange glitch and the back end twitches every 10s or so its really frustrating because I'm unsure what …
-
Sampling accelerometer at 100Hz causes heavy aliasing (anything over 50Hz is aliased).
Internal ACC lpf is set to 188Hz (neccesary for good gyro performance), making things even worse.
BARO mode is …
-
@mcharleb, @jywilson
When the write of i2c.c is used, this leads to different ADSP restarts.
This needs investigation and fixing to make the HMC5883 driver work properly.
It is not clear to me if thi…
-
## Problem
The board does not arm with stick commands or a switch. Instead the green LED flashes. The board may arm intermittently if you keep trying.
## Setup
**Board**: Naze rev6b
**Versions**: Be…
-
I just tried betaflight, wow! Very impressive, so locked in compared to fp-pid. It felt like i became a twice as good pilot!
Could we get this performance in inav? Why having to compromise between na…