-
Every time I move the accelerometer from the Bean, the data jumps around. I need to make it not react to tiny motions
-
### Have you read a contributing guide?
- [X] I have read CONTRIBUTING.md
- [X] I have searched the existing requests and didn't find any that were similar
- [X] I have considered creating a pull req…
-
## Habitat-Lab and Habitat-Sim versions
Habitat-Lab: master
Habitat-Sim: master
Habitat is under active development, and we advise users to restrict themselves to stable releases. Are you using…
-
I like to bind j and k to gj and gk so that my cursor doens't skip over wrapped lines. Tho it seems that this works just fine with the following bind:
```
{"keys": ["j"], "command": "press_key", "arg…
kozie updated
8 years ago
-
### What happened?
According to the documentation NYCE 3041 motion sensors are supported but the battery % and temperature aren't shown on any of my ten 3041 sensors. Motion is detected though.
…
-
## Description
Subtask under : https://github.com/cord-network/community/issues/7
New testcase can be tested under `cargo test -p pallet-collective` after adding it in the code.
## Goals
- […
-
For some reason the slideshow never leaves the Radar/Satellite screen. It goes through the motions with the slides that come before it, but when it hits the radar screen it just stays there forever.
k4gnr updated
10 months ago
-
### Describe the solution you'd like
Hi Team,
The Homebase S380 is able to differentiate between motion detections (face, human, pet, vehicle).
I would like to have a separate switch/accessory f…
-
I can't select a line by typing `V` in normal mode in the app. Will you please take a look?
-
I have generated motions in the format of [nframes, njoints, xyz], especially njoints=21. And I have no idea about fitting them to smpl mesh. Can you give me some advice?