-
Hi,
I don't have this radio but I am curious about the ability to read the firmware and also upload unecrypted firmware
Normally bootloaders in Baofeng and TYT radios don't have the ability to r…
-
Since "issues" here are also about "new ideas", then I have a question: Do you know, if the squelch calibration values are hidden somewhere in the firmware? Is it possible to recalibrate squelch to hi…
-
When I fire up qdmr, it sees my cabling and such on the correct port (ttyUSB0), but sees the AT-878uvii as a Baofeng DR-1801UV now. If I try to just use that, it still will not read from the radio.
…
-
Необходима железария:
- [x] 1x Core switch - 24p Gbit min preferred 48p - Cisco 3760
- [x] 1x Team/noc switch - 24p Gbit min - Cisco 3570G
- [x] 3x Videoteam switch - 10p gbit - TP-Link 3210SG…
-
This isn't an issue, but I didn't want to create a Wiki until I was sure this worked.
I created a Digikey shopping cart that contains all of the parts (except the board itself) that you'll need to bu…
-
mert@mert-Inspiron-15-3567:~$ dmrconf -V -D /dev/usbTTY0 -R dm1701 detect
Debug in cli/autodetect.cc@40: Autodetect radios.
Debug in lib/usbserial.cc@117: Search for serial port with matching VID:PI…
-
The RF24 modules are pumping out pretty low range. Possibly turning down the bitrate and adding an antenna could fix this, but I'm not totally sure. Maybe before full deployment we could either swap r…
-
I spent a few hours this afternoon attempting to try the new cats option. I programmed a sequence of APRS, Hv2, cats with 30 second repeating cycle. APRS and HV2 both transmitted and decoded. I could …
-
```
What steps will reproduce the problem?
1.In VFO mode, VFO A; set offset (menu 26) to any nymber, exaple 00.600
2.In SFT-D (menu 25) set it to - (negative)
3.Download the device configuration.
4.Lo…
-
In Chapter 6. Dual Watch it says that "Certain functions are not available while in dual watch mode:"
With newer firmware revisions, these limitations have been removed (the first 2 anyway).