-
Most RepRapFirmware setups are network connected, so it would be nice to be able to upload (and start printing of) gcode files directly from Kiri:Moto. Refer to the [Developer Documentation](https://r…
oliof updated
3 years ago
-
Hi, Mr dc42!
Thanks for your share first! I down your DuetSiFiServer and CoreESP8266 project, however, when I import them to eclipse, there is no "Makefile" in both of them.
Do you miss upload them ?…
-
I've been trying to get esp-open-rtos running on my ESP8266 and it seems to work nicely when running in station mode, but when I change to softAP mode and try to ping the IP address, it stops respondi…
-
Hi,
Just upgraded to this laptop, which I believe has a 13th gen intel CPU.
Anyways, I tried a clean install via volteer image and 110 brunch and various hardware does not function: -
sound
…
-
### Version
1.41.1-rc
### Operating system type + version
Win10 64bit
### Behavior
No ability to control WHICH fans are used...
_Is this a new feature request?_
Basically, unless there …
-
-
I've got the 7 inch RRF version, I made the mistake in thinking that it is open source, my bad.
Since i cannot do anything myself i can as well tell you what i think needs improvement.
I hate non im…
-
GCode makes sense simple printer commands like movement, particularly on old/slow control board but makes no sense as an actual scripting language and is being misused for complex config and logic.
…
-
The V3.0 J-head hot end link to the amazon part is out of stock without an estimated replenishment date, is there a recommended replacement? Could this work with a Bowden extruder? I am not sure how t…
-
So this is my current list of the things I'm planning on working on (in a very rough priority order)...
1. ~~Create single code base for STM/LPC versions and associated build system.~~
2. Track DC42…