-
Hi vitormhenrique,
I am using octoprint on a Raspberry PI 2B.
With GPIO 23 I control a lamp via pwm.
 value 3 & 4 may be the duty cycle.
Here are some valu…
-
The CDB field StatusSocketDutyCycle is now set to 30ms. The ACU sends a message every 100ms. This means the socket will pick up the first message 20ms after it is actually sent, and so on, like the fo…
-
For speed reasons, this is probably best implemented on the DeepBlueSim side so that it can use Webots methods as appropriate and avoid the round-trip communications latency that would be required if …
-
ISO 15118 is a communication protocol standard specifically designed for the communication between electric vehicles (EVs) and charging stations, including AC chargers. Enables exchange of various dat…
-
I have a question regarding the general protocol: How long does sending a request to the inverter take (in milliseconds)? For how long does the inverter send back its information (in milliseconds)?
…
-
Hello,
we use this Infineon Mosfets:
BTS7030-2EPA
and we drive it either with GPIO or with PWM. We use the LEDC Module from Espressif, which is great.
as one Channel can drive 4A, it woul…
-
- [x] H bridge hardware/software driver validation
> - [x] Determine max frequency
- [ ] Motor characterization
> - [x] Create test hardware
> - [ ] Figure out adjusting teensy PWM to custom frequency…
-
1. Please add stop simulation button. In one of the example project I see the motor still spinning even if simulation is paused
2. Add named nodes feature to make circuit more neat and clean. See vol…
-
**_Reported by Javier B Perez:_**
Low duty cycle direct LE advertising
(Imported from Jira ZEP-28)