-
### Describe the Bug
Chain drives with one section rotated that transmits power to fan change direction (clockwise/anticlockwise) and subsequentially flip fan pull/push effect when rotated 90 degre…
-
Basically, wondering if I can run 24 volts for my motors and 12 volts for the main board to include the heater, fans, etc.
-
**Describe the problem you have/What new integration you would like**
I would like to use the Hbridge platform to drive a bistable valve solenoid or a motor without speed control or anything else…
-
So, today I have installed a S6 board on my ender 3. Drivers, endstops, stepper motors, bed and hotend work find, but I have a strange behavior when I power on pwm layer fan. Infact in FAN0 connector…
-
I have issue with the Controller Fan - setting speed or the idle time.
here is my settings in Configuration_adv.h
#define USE_CONTROLLER_FAN
#if ENABLED(USE_CONTROLLER_FAN)
#define CONTROL…
-
Right now, the architecture of phosphor-pid-control assumes each thermal zone will have 2 cascaded PID loops:
* The thermal loop, to decide on the necessary fan RPM to keep the system cool
* The f…
-
Initial control algorithm should be designed to control a fan motor in open loop.
How can this be done on a microcontroller?
What type of algorithm should be used?
-
Hi. Hope someone can help me. The board works fine, which mens i can upload new firmware and i can control fans and other hardware devices using PrintRun for Mac. But when i try to control the stepper…
-
When engaging any of the stepper motors (i.e., X axis, Y axis, Z axis, Extruder) the fan remains off.
**Expected behavior**
Fan1 (control board cooling fan) should run when any of the stepper …
-
### Version
PrusaSlicer 2.1.0+win64-201909160915
### Operating system type + version
Microsoft Windows 10 (64-bit)
### 3D printer brand / version + firmware version (if known)
Creality Ender …