-
Sorry for the topic itself isn’t a real issue at all. I have been use fettec alpha a long while now, and I hope you add the support for it. It has a lot potential really. Thanks again for your brillia…
-
The esc firmware update freezes, if you have the newest firmware (1.3RC45y) on your FC.
I had to downgrade to (1.3RC40o) and after that the esc firmware update worked.
I'm using macOS
-
the halfduplex pull up/down setup on serial IO config workes wrong when using pushpull and half duplex (SERIAL_BIDIR | SERIAL_BIDIR_PP).
see:
https://github.com/betaflight/betaflight/blob/master…
-
### Describe the bug
If connecting fettec mini LED (5 in a row) on the regular LED pads (gnd, 5v, Signal) and configure in LED Tab with led low modi, this will result in destroyed LED. They wont work…
-
Hello,
The new FETTec Alpha Firmware is using MSP Display Port for the OSD. Is it possible to implement MSP Display Port on the ImpulseRC Apex OSD? I'm getting "FC Not Detected".
Thank you!
-
I have 3 nearly identical Apex. All have the FETtec F7 and 45A (except one with the Flyduino ESC) running 4S, regulator board, Apex OSD, Unify 5V V3, Falkor V2. Both the FETtec ESC builds have spike a…
udyux updated
3 years ago
-
This was raised as part of Rover-4.1.0 beta testing here: https://discuss.ardupilot.org/t/brushedbipolar-pwm-problem/76153
-
Hi everyone. Is it possible that faulty apexosd fried my FCs (fettec fc)? The green (picture below) element was loose, touching the red one. @awolf78 do you think that this might cause the short and s…
-
I noticed there was a recent update to Fettec firmware so I updated, and now the KKC won't connect, and instead gives me an "update firmware" screen. Is this because of the KKC or my FC?
-
I have kiss v1 fc and fettec 45a esc. although I did all the connections right. There is nothing wrong with the kiss v1 connection, but the fettec configurator connection does not work. "esc not found…