-
Hi,
I have been using p2pp for a very long time - and it just works! Great job!
Lately, I have experience a problem with my Palette2s running in connected mode with klipper.
I slice using pr…
-
Hi, can you help me please?
I have no idea to which connector on the sb2209 board I can connect filament sesor which I have in the tool head Stealthburner.
Thank you so much
-
### Version
PrusaSlicer 2.1.0-rc
### Operating system type + version
All.
MacOS v10.14.6
### 3D printer brand / version + firmware version (if known)
Prusa MK2
### Behavior
Is this a n…
sgano updated
2 months ago
-
What about adding in push notification support? Browsers can actively have this? I.e. visit Duet, then duet requests permissions to send the browser a notifications?
-
### The problem
This happened direct after `Filament Runout Sensor` was triggered. It went into an `ADVANCED_PAUSE_FEATURE` for swapping filament.
Steps:
1. Start OctoPrint and Printer
2. Star…
-
Firmware: 3.2.1-576
It started when a print I downloaded a file from thingiverse.com [https://www.thingiverse.com/make:496393].
Imported it to prusa control. Then started printing, it wanted to …
-
Hi @furbrain!
At our local caving club we have received the SAP6 and have already field-tested it. There were some changes in measurements compared to the Disto-X2, but the Disto-X2 was not calibra…
-
We should get a or be able to enable a notification for filament runout
-
If I perform your firmware update for the functionality of the Titan Aero, in the CR-10S, will I lose the original features, of the no filament detection, and the loss of Power Resume Feature?
-
Hi.
I have been testing my filament runout sensor made with a microswitch.
When the filament is inserted into the sensor the Resumer3D shows PA1 Down on BoxTool's output.
Is this correct, or should…