-
This issue documents a verification run for "fast math" (`-ffast-math` on `gcc` or `--use_fast_math` on `nvcc`).
I suspect that for long running simulations (e.g. 30k steps and more), it has a sign…
-
### Description
I did install a 3D-Touch bed leveling sensor on my printer and configured it into the firmware according to the Marlin configuration. The System locks up, if the LVGL-GUI is used in c…
-
Hello! I printed the original design (all standard core parts) around mid 2019 and have been tracking the changes like cooling fan clearance, x idler, cable connectors, etc. Do you plan to update the …
-
Hi there,
I've got a custom built Taz 6 that uses an Archim 2 board, has Belted Z, Hemera toolhead, a USB flash interface, dual filament runout detection, a "modern" carriage, on the Taz 6 spec fra…
-
>
> Dear Nibbels:
I copied the e3d-toolchanger-config in your project from github today. I found a problem during use?
My configuration is as follows:
Board: Duet 2 WiFi (2WiFi)
Firmware: Re…
-
The fang duct blows too much on the heated block causing a drop in temp when activated.
A sock and pid calibration with the fan on can help mitigate the issue.
-
After testing with both units the stock extruder does not appear to be sufficient to produce dimensionally accurate prints.
used https://makershop.co/3d-printer-extruder-calibration-steps/ and th3ds…
-
We saw the following [error message in PIConGPU](https://github.com/ComputationalRadiationPhysics/picongpu/issues/3506#issuecomment-781625774)
```
terminate called after throwing an instance of 's…
-
12-13 15:55:27.919 16685 16707 E CRASH : signal 11 (SIGSEGV), code 1 (SEGV_MAPERR), fault addr fffd807557a29978
12-13 15:55:27.919 16685 16707 E CRASH : *** *** *** *** *** *** *** *** *** *** **…
-
In seneca 3.2.1, when an error is thrown during an act call, it is correctly handled and forwarded to caller.
But the exception is being wrapped in a seneca eraro 'act_execute' error which is not usef…