-
My new board is exactly as shown here https://github.com/LilyGO/TTGO-LoRa32-V2.1
How to access GPIO0 at this board?
I've got problmes uploading my code using Platformio because of permanent time…
-
#### Description
Cannot format using vfs_format on Heltec Lora v2 (esp32-heltec-lora32-v2)
#### Steps to reproduce the issue
I'm following the SPIFFs example (https://github.com/RIOT-OS/RIOT/tree…
-
Hi guys,
Trying to compile code and upload to my TTGO Lora32 T3_1.6.1. I can compile the source (firmware) without problems and it uploads to my device but when I run the pio monitor command I see I…
-
In example code ttn-abp, I get error in subject at line
os_setTimedCallback(&sendjob, os_getTime()+sec2osticks(TX_INTERVAL), do_send);
The board is TTGO LoRa32. What can I do?
-
Please change OLED_RST to 0 (unused). The original GPIO 16 is used for Flash_CS on the board and change L_RST to 23, as the SX1276 reset is connected to GPIO23. Board worked now with this board templa…
-
When attached to the serial monitor, the logs are flooded with a print buffer deprecation error, here is an example of the logs from boot (DevEUI, AppEUI, AppKey & location redacted):
```
rst:0x1 (P…
-
## Summary
Hello,
I'm reaching out as a user of ESP32 LILYGO® LoRa32 V2.1_1.6, and I've observed limitations with the Softwareserial and HardwareSerial libraries. The Canairio library mandates the…
-
### Describe you new feature you'd like
There are two suggestions i see when i look at this amazing project:
- Size constrains (cause you are always complaining about it)
- You can advice the com…
-
I've installed the recent version to an Lora32 v2.1 and a T-Beam 1.1 and both show no received packets in the web interface although they are received and forwarded via KISS.
-
I have seen a wrong pinmap in the image in this repository. The Pinmap image shows ` GPIO2, GND, 5V ` and the Schematics 1in6 on Repository [../TTGO-LoRa32/schematic1in6.pdf](LilyGo/TTGO-LoRa32/schem…