-
Hi,
this project is pretty frozen so i create a new project and add a new web interface.
I release It some days ago.
https://www.mischianti.org/category/project/web-interface-beeprint-for-mks-wifi/…
-
### Plugin Version
1.4.2
### Cura Version
5.2.2
### Platform
Windows 10
### Printer
Creality Ender 3 Pro with MKS Nano Robin v3.1 and TFT35 v2
### Reproduction steps
1. Upgraded my printer wi…
-
I bought a MKS Robin WIFI, installed on my FLSun SR (MKS Nano 3), set my WIFI data and upload your firmware.
When I try to access to web interface I can see your interface and, on start, the messagge…
-
Передача wi-fi под прошивкой WiFi MKS может достигать 100-200kb/s, но в настоящее время, используя WiFi прошивку шуи только 10-20kb/s, могу я спросить, можно ли получить более быстрое обновление прото…
-
### Version
_v2.4.0_
### Operating system type + version
Any operating system
### 3D printer brand / version + firmware version (if known)
mks.wifi family
### Behavior
mks.wifi does not h…
-
В Cura установлен этот плагин https://github.com/Jeredian/mks-wifi-plugin
Для паузы и возобновления печати отправляет M24 и M25. Для завершения печати M26 (что не корретно для Marlin, для этого есть …
-
I cannot connect via USB. Tried several ways and times. Re-flashed several times. Using an MKS Pi V1.1 for Klipper. I am trying to use UART for my RX/TX MCU communication. I set the firmware to UART1 …
3dOA updated
10 months ago
-
**Describe the bug**
When starting up pi controller (MKS Pi), octodash has about a 30% chance of starting properly. I don't have this issue when just running octoprint.
**To Reproduce**
Steps to…
-
Hello,
When I try to connect my MKS TFT using a MKS ESP8266 to my wifi, I am prompted for the WiFi password which contains an exclamation mark ( "!" )
However, when I press the exclamation mark it…
-
Hi, I'm having issues lately after I compiled this source and installed on the module.
Any one facing same problems?