-
I am using the Portenta H7 with Portenta Cat. M1/NB IoT GNSS Shield, tying to run MicroNMEA_integration.ino example in the Arduino IDE. My GPS device is returning valid strings with data for $GPGGA an…
-
# Summary
Arduino IoT Cloud identifies the Portenta H7 and is able to trigger a soft reset via the Arduino Create Agent. However, upload loading the sketch if faces an `exit status 74` error. I ha…
-
Hello 👋,
I am using an Arduino Portenta H7, and an analog light sensor. I tested the sensor with the on-board ADC of the arduino (analogRead) and I can read the values (so the sensor works).
Thi…
-
I can't for the life of me get this working I am using the new Portenta H7 and and trying to run the samples for the BNO080.
I am using the Qwiic Cable - Breadboard Jumper (4-pin) to connect to the …
-
we would like to try out the AIfES framework to evaluate the execution of a model built with Keras.
Can BiDirectional network models from Keras be translated into an implementation that runs, for exa…
-
Following testing with both Renesas configurations (Portenta C33 with Vision Shield & Breakout) as well as mbed (Portenta H7 + Vision Shield), it is observed that the maximum path length is 255 charac…
-
I ran the CoreMark benchmark on Portenta. It's running significantly slower than M7 at 480 MHz should. Most of the poor performance is due to line 14 in variants/PORTENTA_H7_M7/cflags.txt.
-O…
-
As the title says. Reproducer sketch:
```c++
#include
// --------------------------------------------------------------------------------
// remove_reference
template
struct remove_referenc…
-
I'm looking to port my Modular Sensors based code over to an Arduino Portenta H7, which has a STM32H7 cpu. Is there a starting point you'd recommend for adding to the library to make it work for this …
-
Hardware: Arduino Portenta H7 + Dynamixel MKR Shield
Using 11.1v 3S Li-Po as power source, V and G measure correct on the TTL connector but running the example `scan_dynamixel` found no servos. The D…