-
Hello everybody,
I already searched around on the opportunity, to switch on and off the Motion Notification function in motioneye via shell command, like one can also start and stop Motion Detectio…
-
### The problem
I seem to be getting a compile error when trying to enable the "remote_receiver:" option in the yaml config using the RP2040 platform.
`remote_receiver:`
` pin: GPIO20`
` dump: a…
-
There will need to be some code written for sending the data, that is collected from the sensors by the Arduino, to the Raspberry Pi (under the current plan). The way this is currently going to be don…
-
### Link
https://moeshouse.com/products/zigbee-wireless-self-powered-scene-switch
### Database entry
{"id":76,"type":"GreenPower","ieeeAddr":"0x00000000a3970ea3","nwkAddr":3747,"manufId":null,"mode…
-
I'm using Raspberry Pi 3 Model B+.
```vcgencmd get_camera``` gives me ```supported=1 detected=1```
```raspistill -o test.jpg``` gives me the test.jpg file but also gives this message
```
mmal:…
-
Cameras (listed with IPs):
1.45 changmi.camera.ipc009 (Mijia 360 1080P, MJSXJ02CM)
1.46 mijia.camera.v3 (Mijia Camera 1080P, SXJ02ZM)
Tokens extracted with MiHome (tokens for Air Purifier and Ph…
-
### Describe the issue you are experiencing
After upgrade to 12.3 my Home Assistant SkyConnect/ZHA is no longer working.
I've tried every possible reboot and restore from backup combination possi…
-
## The problem
I can only control my socket from one Home Assistant server. The device on the second server becomes unavailable.
But when the server is rebooted, where the devices were available, an…
-
Hi Zach. Firstly thank you for your work on this. I've followed your steps multiple times and I never seem to get a config.json file created when I reach that step. I get lots of errors along the way …
-
## Verify the following before opening an trouble issue
**Go over all the following points, and put an `x` in all the boxes that apply.
If you're unsure about any of these, don't hesitate to ask. …