-
Hi
With D3 and D5 fitted the detected USB device is unrecognised. Removing D3 and D5 resolves the issue.
Burden resistors at 4.8 ohms this seems a little low would 6.8 ohms be a better value?
Tha…
-
Is the pull-up resistor actually needed? The web says that the NGC controller has a 745 ohm pull-up already.
-
When I used a 1M resistor for attenuation, I could barely register a 3.3V input. I got about 50% attenuation with a 100K resistor (though also some signal distortion). Are you sure you meant 1M?
-
I was looking at resistors library and I cannot find exactly what I need. I also suck at making own footprints. :/
It is about 4 terminal SMD shunt resistors (for measuring current).
Example:
…
-
First of all, thanks for a creating such a great tool.
I've been exploring some of the noise support recently and ran into an issue. It seems that the sign of the PSD contribution of `white_noise()…
-
I am contemplating building my own SCART cables and for PAL SNES I need to place 75 ohm resistors instead of 220uf caps. I could just place these on CR1, CG1 & CB1 and bridge the others right?
-
The Portenta documentation and 4-20mA example for the analog inputs specifies a 120 ohm resistance and 3.0V reference voltage, when the input is put into the 4-20mA mode. However, the design of the …
-
_From [irasc...@gmail.com](https://code.google.com/u/104729248032245122687/) on May 19, 2013 01:49:57_
"When choosing resistors, I was searching and not finding the 700mil length. This should be adde…
-
Making a pinout for the JTAG pins (MTDI, MTDO, etc.) and fixing strapping issues with time delay pullups / pulldowns should enable this.
Example circuit (that I think is correct):
![Screenshot 202…
-
Would it be possible to include the original resistor.jpg image? I am working on resizing the project to fit a 2.4" TFT screen and would love a slightly larger image.