-
I am running a system with a EmonTx/RFM12B as the transmitter and a Raspberry Pi/RFM69 as a receiver. That works just fine.
I have replaced the receiver with a RTL-SDR dongle. I have done a few tests…
-
Might it be possible to move some of the RFM12B configuration details from the library to the sketch. i.e.
// #define PINCHG_IRQ 1 // uncomment this to use pin-change interrupts
# define RFM_IRQ …
-
The rf12mods library has:
`void rf12_control(uint16_t cmd)`
while the original jeelib:
`uint16_t rf12_control(uint16_t cmd)`
This change breaks code that uses rf12_control() to read the status regis…
dzach updated
6 years ago
-
This issue is intended to discuss new functions for the RF12 driver, and its required interfaces. issues to be discussed.
- replace rf12_control() by rf12_xfer, or remove the function at all from exte…
-
Hi everyone,
I've made a sketch works on attiny84, and i 've tried to upload on a attiny87, no compilation errors (i've included correct pin_arduino.h, tiny core). but the attiny freeze on rf12_confi…
-
I am unsure if the latest changes to this branch have caused this but the pin change interrupt mechanism is now broken.
I am surprised to see that the pin change interrupt mechanism is now working f…
-
Is it possible to make a general listener for my no-name weather station working on 868 Mhz? With this way, I am aiming to reverse engineering on its protocol/data frame.
Any input greatly appreciate…
-
Does this project support RFM69?
-
The Spectrum only shows an orange block of the same level of e.g. -67 dBm for alle frequencies. There is no difference in rssi from 860 to 880 MHz.
What could be the reason?
plin2 updated
6 years ago
-
All,
Been away a while - again!!
I see lots small changes in RF12, Is there a RoadMap anywhere:
I just quickly scrolled through and sort of picked out the following:
JNu - I can see some #defines t…