-
### Version
4.1.6 (or even with 4.2.65)
### Issue description
Hi,
I can use all analog pins from my Arduino Nano (clone) as sensors (using pin A0 to A5 (#14 to 19)) but I'm not able to use A6 an…
-
*Sent by (dccextended@gmail.com). Created by [fire](https://fire.fundersclub.com/).*
---
## Dirk created a ticket
Name: Dirk Haan
Email: cardiohe@icloud.com
Timezone: 1
Software: EX-CommandStat…
-
*Sent by Michael M. (mikey_1955@hotmail.com). Created by [fire](https://fire.fundersclub.com/).*
---
Hello dcc-ex support,
@FlightRisk I'm sorry, but I'm not getting on with the Discord website. For…
-
Locos do not resume their speed when initially connected or have reconnected after a partial or full disconnect. An additional Rocrail command is required to get the loco started - or stopped in certa…
-
All sensors configured in a MLC should be reported to Rocrail after successfully establishing the network and MQTT connection.
Should be tested with directly connected sensors and some connected via …
-
Locos do not resume their last received fn command when initially connected. An additional Rocrail fn command is required to get the light on or off. To overcome this problem, you could set the presen…
-
Do not check for AllHubsCOnnected, we should change it to:
ForAllHubsConnected....
```
void BLELocomotive::SetEmergencyBrake(const bool enabled)
{
if (!AllHubsConnected()) {
// Ignor…
-
Hi,
I tested 4 displays on the white board, it went great, then I connected the purple wire (GND) and the red wire (5v) to the busch distribution board and that also worked, so I'm done with this a…
-
Hi,
I am expanding the display buttons in rocrail for extra messages, but that is not going well, display button 4 will not appear, what have I forgotten or what am I doing wrong, see the printscre…
-
Hi,
Now that display 1 is almost ready, I want to start on display 2, 3 and 4, I am building a large station with 4 platforms with 1 display each, the question is how do I build it? I know that eve…