-
Hi, I am no electronics guru, but here are my suggestions.
## Schematic:
- Move C7 as shown on the screenshot. When buck converter operates, the current flowing between C7 and Q2 is a square wave. I…
-
Hi Mick,
I know that your busy, so if you could email me a hand drawn schematic of your new talking clock i'll create an electronic version for you.
Cheers mate
Paul C
-
Notes for flight model improvement:
**Schematic:**
- [x] add to debugging header: ADC measurements, SPI (SCK, MOSI, MISO, CS for each device), CAN (CANH, CANL), maybe I2C
**Layout:**
- [ ] tes…
-
I'm also trying to use a STM32 without a DAC to produce music.
I it is possible to have a schematic of the electronic, I assume you do some filtering and amplification?
> There is implemented virt…
-
Hello, thank you very much for this schematic!
Hope you don't mind if I post a question here.
On the D4184 board do you think this situation would cause a short:
1) Directly connecting Vout+ and…
-
* Mark r35 and r34 as not placed
* Mark r30 and c16 as not placed
* Move murata reset button to more available position
* Add decoupling capacitors to gps, bme, eeprom.
* Beautify schematics, here…
-
Hi, I'm trying to build a drone (esp32c3-based) inspired by an esp-drone project and I've got a problem with power supply.
Whenever the motors start spinning more than ~20% of their max power, **the …
-
Hi Simos and thank you for sharing this nice project ! :+1:
I'd have some questions or comments to you regarding mostly the form :
- There are several PDF schematics (such as FlexiBMS.pdf, Flex…
-
-
Firstly, this project is pretty awesome! Sadly a huge amount of the most complicated FOSS hardware is in Altium format :-( The guys from Upverter seem to have attempted to do something similar with ht…