-
I have the same motherboard and was looking at your VS code. First question is does it work? I don't have a sensor mounted yet nor do I want filament run-out yet. Something stuck out that you have E2 …
-
I don't see the pin assignments for the run-out sensors? I also noticed that you have the drivers defined as a4988 instead of tmc2208_standalone.
-
So i have a BTT GTR v1.0 and 6 BTT TMC 2208's V3.0 UART's
Now the problem is . 4 test with no errors 2 test with errors.
Firmware: Marlin
Version: CONFIGURATION_H_VERSION 020008
17:05:37.…
-
I have a new SKR 2 rev B board and 5 BTT TMC2208 v3 stepsticks - I am getting "TMC CONNECTION ERROR" from the display at boot up, and M122 just shows:
Testing X connection... Error: All LOW
…
-
Is it necessary to add 1K Ohm on a Y cable for the Tx line or does the CNC shield already have this?
-
Hello everyone.
I have a SKR Mini E3 V1.2.
I'm trying to compile the new firmware with bltouch.
The instruction from bltouch page says to uncomment
#define ENDSTOP_INTERRUPTS_FEATURE
When compi…
-
![IMG_20190712_150101](https://user-images.githubusercontent.com/52832571/61143131-0b3ec680-a4da-11e9-822b-144743e995d1.jpg)
`Compiling .pioenvs\BIGTREE_SKR_MINI\src\src\HAL\HAL_STM32F1\persistent_…
-
Soldered the 2 of the 3 pads missing the 0ohm resistor together, UART now works with M122 no errors, but now it wont do a G29?
G28 works fine, but when I test G29 it lowers my bed, like its already…
-
Hi guys!
I've installed TMC2208 UART to skr 1.4Turbo by removing 3 shorting caps under stepstick and leaving only UART shorting cap, also i've got soldered this two pads.
Altho. When i'm trying t…
-
Lack of files for v2.0 and v2.1 of TMC2208.
Aliexpress or FB isn't right place for technical information. Put all needed manuals and information on Github, Wiki or Your company web page.